This tab is designed to specify the device used for reading and writing discs. Once the reading process is complete, the same drive is used as the device for writing the temporary image file to a blank disc.

Each time you start DiscJuggler, it performs a scan to identify all supported drives attached to the system. In this task, all drives found to be suitable as both input and output devices are listed. You can only select one device at a time.

After a writing drive has been selected, DiscJuggler will continuously poll the selected device to read the Table of Contents (TOC) of the mounted media and will display a short description of disc contents under the list of devices.

DiscJuggler will not start a duplication session until a non-blank disc is placed in the selected device and will prompt for a blank disc at the appropriate time (after a complete image of the disc has been temporarily copied to a local hard disk).

Note: Clicking on the writing drive icon will eject the media mounted in the selected drive. Clicking on the writing drive icon while pressing the <Ctrl> key will load, if possible, the media mounted in the selected drive.