This task operates with autoloader devices to fully automate the disc printing process. This task doesn't require the presence of reading or writing drives. Make sure that the autoloader input bin is loaded with printable media compatible with the associated disc printer (usually the disc printer is mounted inside or on top of the autoloader unit).

The Start button will be active only if an autoloader unit has been selected in the Destination section.

Destination:

This section lists all autoloaders that can be used to perform this task. Select desired autoloaders from the list to begin using the task.

Copies:

With this option you can specify the exact number of discs that you want to print. Make sure you load the autoloader input bin with a number of re-writable discs grater or equal to the number specified here. The special "Auto" value can be selected in which case DiscJuggler will process the task until the autoloader input bin is empty.

Cycle only (do not print):

Allows the robotic elements of the autoloader system to be exercised for purposes of testing or demonstrating without actually printing.

Skip clean-up procedure:

When DiscJuggler starts a new task where an autoloader is being used, it assumes all the drives in the unit are empty and trays closed. If you are sure that all drives are empty and trays closed, you can use this option to skip the clean-up procedure and save time.

CD/DVD Printer:

DiscJuggler allows you to specify label files that will be sent directly to the disc printer.

See the Autoloader panel in section Create new CDs for a detailed description of this component.