The Job panel provides ways to modify the default behavior of DiscJuggler during the disc writing process. More specifically, this tab changes the behavior of DiscJuggler at the beginning and end of each writing cycle.

The following options are available.

• At the beginning of every cycle:
   

• Wait for user confirmation
  
  When the number of copies requested are higher than the number of drives, this setting will require the user to press "OK" or "Cancel" before writing to the next cycle of discs.
   

• Start when the required number of media are detected
  
  This will start the next cycle of writing as soon as all the required blank media has been inserted into the writing drives.
   

• At the end of every cycle:
   

• Open all drives
   

• Do not open any drive
   

• Open only drives that have succeeded
   

• Open only drives that have failed
   

• Multiple drive selection
   

• Mix and match any drive
   

• Drive must be of the same make and model
   

• Drive must be of the same make and model and have the same firmware