The Verify panel allows you to set the verification process, a bit-by-bit comparison of the source information and resulting disc. You can choose to verify every disc, the first disc of a multiple disc duplication task, or set the verification frequency when burning several discs. You can also choose to verify the temporary images created by DiscJuggler. Finally, you can instruct DiscJuggler to correct errors found when reading CDs in RAW mode.

Verify every cycle:

When selected, this option instructs DiscJuggler to perform a bit-by-bit verification of every recorded disc, including those that have been recorded simultaneously during the cycle. Select this option when data integrity is the most important factor. This option will nearly double duplication time. This option is effective only if "Verify" is selected in the Action panel. However, no verification is performed for Audio CDs or their tracks as all possible verification is done during the recording process.

Verify only first cycle:

When selected, instructs DiscJuggler to perform a bit-by-bit verification of the first recording cycle only, where "cycle" means the discs simultaneously recorded in one or more recorders. Select this option to check system integrity and when data integrity is not a crucial factor. This option is effective only if "Verify" is selected in the Action panel.

Verify a cycle every:

When selected, instructs DiscJuggler to perform a bit-by-bit verification process every n cycles recorded. Select this option to periodically check system integrity. Use the associated edit field to select the verification frequency: enter a number higher than 1. This option is effective only if "Verify" is selected in the Action panel.

Verify temporary CD/DVD Image:

When this option is selected, whenever DiscJuggler generates a temporary DiscJuggler Image, a bit-by-bit verification will be performed between the source disc and the image to ensure that no errors occurred during the read process. This option is effective only if "Verify" is selected in the Action panel.

Check data blocks with software generated EDC/ECC when reading in RAW mode:

When reading CDs in RAW mode, DiscJuggler disables the hardware ECC/EDC performed by the reading drive. To ensure the highest data integrity, DiscJuggler will perform software ECC/EDC on all blocks when this option is selected.