The Log panel allows you to control the contents of the log file generated by DiscJuggler during each duplication session. You can request that DiscJuggler maintain the log up to a maximum number of entries (at which point earlier entries are deleted) or to delete log entries that are older than a specified number of days. It is also possible to clear the log each time information from a new task is entered. If this option is selected, than the option to confirm the deletion of existing log information is enabled. Finally, you can choose to "filter" log entries by moving the slider so that only a certain level of logging is included.

Maximum number of entries:

By selecting this checkbox and entering a positive number, you force the DiscJuggler Status panel to discard events in excess of the specified number. Older entries will be deleted.

Remove entries older than:

By selecting this checkbox and entering a positive number, you force the DiscJuggler Status panel to discard events older than the specified number of days.

Clear on Write:

When this box is checked, DiscJuggler will empty the corresponding Status panel every time a duplication task is started.

Confirm:

If this box is checked, DiscJuggler will ask for confirmation before erasing the document task log.

Filter:

This slider controls DiscJuggler verbosity. It ranges from "Filter None" where all events are displayed and logged, to "Filter All" where only fatal events will be displayed.