The Autoloader panel displays information concerning the selected robotics device and associated reading and writing drives.

The information displayed at this level pertains to robotic devices as a whole and includes the capabilities of the autoloader, the blank media capacity, drives, rejects, mail slot, interface, and printer availability.

• Autoloader model

• Firmware/BIOS revision

• Type of interface used by the robotics device to communicate with the computer

• Type of robotics: this can be either sequential (autoloaders) or random (jukebox) access

• If the autoloader has a disc printer connected

• If the autoloader has a mail-slot to eject discs one by one

• The maximum number of writing drives the autoloader can support

• The maximum number of blank discs that can be loaded at once

• The maximum number of rejected discs that the unit can hold

Details concerning the devices connected to the autoloader are shown by clicking on the "+" next to the selected unit in the Device Explorer tree or double-clicking it.

Alias:

To better identify devices of the same type, simultaneously connected to the computer, DiscJuggler offers the ability to assign an "Alias" to a device. When you assign an alias to a device and press the <Update> button, DiscJuggler will always refer to that unit with its new name. For example if you have two identical autoloaders connected to the same computer you could name one "Left Autoloader" and the other "Right Autoloader".

To remove an alias and have DiscJuggler use the original name just leave the field empty and press the <Update> button.